Pioneer VSX-1326-K Operating Instructions Manual page 80

13 Additional information
Symptom Remedy
Lower frequency response Low frequencies used in bass management (the subwoofer channel) will not
curves do not seem to have change for speakers that have been specified as SMALL in the configuration,
been calibrated for SMALL or do not output these frequencies.
speakers.
Calibration is performed, but due to your speakers' low frequency limitations,
no measurable sound is output for display.
Display
Symptom Remedy
The display is dark or off. Press DIMMER repeatedly to select a different brightness.
You can't get DIGITAL to dis- Check the digital connections and make sure that the digital inputs are
play when using SIGNAL SEL. assigned correctly (see The Input Setup menu on page 28 ).
These indicators do not light if playback is paused.
2 DIGITAL or DTS does not
light when playing Dolby/DTS
Check the playback (especially the digital output) settings of the source com-
software.
ponent.
When playing Dolby Digital Check that the player is connected using a digital connection.
or DTS sources, the receiver's
Make sure that the receiver is set to AUTO or DIGITAL (see Choosing the input
format indicators do not light.
signal on page 39 ).
Check that the player isn't set up so that Dolby Digital and DTS sources are
converted to PCM.
Ensure that if there are several audio tracks on the disc, the Dolby Digital or
DTS is selected.
When playing certain discs, The disc may not contain 5.1/6.1 channel material. Check the disc packaging
none of the receiver's format for more on what audio tracks are recorded on the disc.
indicators light.
When playing a disc with the Make sure that the receiver is set to AUTO or DIGITAL (see Choosing the input
listening mode set to Auto Sur- signal on page 39 ).
round or ALC, 2 Pro Logic II
If a two channel soundtrack is currently playing (including Dolby Surround
or DTS Neo:6 appear on the
encoded), then this is not a malfunction. Check the disc packaging for details
receiver.
about the audio tracks available.
During playback of DVD- This will occur when playing DVD-Audio material over the HDMI connection.
Audio, the display shows PCM. This is not a malfunction.
The power turns off auto- See the Power section (page 76).
matically and some indicator
flashes, or some indicator
flashes and the power does not
turn on.
80
En
Remote control
Symptom Remedy
Cannot be remote controlled. Set the remote control unit's remote control mode so that it matches the set-
ting on the main unit (see Operating multiple receivers on page 56 ).
Check whether the receiver's remote control mode is properly set (see Remote
Control Mode Setup on page 74 ).
Try replacing the batteries in the remote control (see Loading the batteries on
page 6 ).
Be sure to operate within 7 m (23 ft.) and a 30º angle of the remote sensor on
the front panel (see Operating range of remote control unit on page 7 ).
Check that there are no obstacles between the receiver and the remote con-
trol.
Make sure that there is no fluorescent or other strong light shining on to the
remote sensor.
Check the connections of the CONTROL IN jacks (see Operating other Pioneer
components with this unit's sensor on page 24 ).
Other components can't be If the battery ran down, the preset codes may have been cleared. Re-enter the
operated with the system preset codes.
remote.
The preset code may be incorrect. Redo the procedure for entering preset
codes.
When commands from the remote control units of other devices are regis-
tered using the learning function, in some cases they may not be learned
properly. In this case, register the commands again using the learning func-
tion (see page 57). If they still do not work, they may be in a special format that
cannot be registered on this receiver's remote control. Operate the device
using another remote control.
HDMI
Symptom Remedy
The HDMI indicator blinks Check all the points below.
continuously.