Table of Contents
Advertisement
The on/off button flashes slowly and the warning light goes out.
,
5
After a few seconds hot water stops coming out of the coffee spout.
The machine is heating up.
,
Automatic rinsing cycle
When the machine has heated up, it performs an automatic rinsing cycle to
clean the internal circuit with fresh water. This takes approximately
one minute.
1
Place a bowl under the coffee spout.
The on/off button flashes slowly.
,
2
Water flows from the coffee spout. Wait until the water stops
coming out of the coffee spout.
Note: You can stop the automatic rinsing cycle by pressing the coffee button.
3
When the on/off button lights up continuously, the machine is ready
to brew coffee.
Note: The automatic rinsing cycle also takes place 15 minutes after the
appliance switches to standby mode or switches off.
Note: The first cups of coffee may be a bit watery, this is normal. The machine
needs to complete a few brewing cycles to optimise its settings.
ENGLISH
11
Advertisement
Chapters
Table of Contents
