If You Are Unable To Finish The Descaling Cycle; Meaning Of Light Signals - Philips HD8650/06 Manual

5 When the on/off button light lights up continuously, remove the
drip tray, rinse it and place it back.
6 Remove the water tank and rinse it.
7 Reinstall the Intenza+ water filter (if present).
8 Fill the water tank with fresh tap water up to the MAX indication
and slide the water tank back into the machine.
9 The machine is ready to brew coffee.
Note: When the 'water tank empty' light lights up continuously and the
descaling light is still flashing, the water tank has not been filled up to the
MAX indication for the rinsing phase. Fill the water tank with fresh water and
resume the rinsing cycle from step 4.

If you are unable to finish the descaling cycle.

If the machine gets stuck in the descaling procedure, you can press the on/
off button.This allows you to complete the descaling procedure. Follow the
steps below to make sure your machine is ready to brew coffee again.
1 Remove the drip tray, rinse it and place it back.
2 Remove the water tank and rinse it. Fill the water tank with fresh tap
water up to the MAX indication and slide the water tank back into
the machine.
3 Press the on/off button to switch on the machine. The machine will
start the automatic rinsing cycle.
4 Place a bowl under the coffee spout.
5 Press the coffee button and brew the amount of 300ml of coffee.

Meaning of light signals

- The on/off button lights up continuously. The machine is ready to brew
coffee.
- The on/off button flashes slowly. The machine is warming up or
performing a procedure.
ENGLISH
21