Table of Contents
Advertisement
24
www.aeg.com
Displayed message
TOO MUCH POWDER
INSERT WATER SPOUT
INSERT MILK CONTAINER
INSERT BREWING UNIT
AIR BUBBLE ALARM
TURN THE MILK FROTH
ADJUSTMENT DIAL TO
<CLEAN> TO START
CLEANING
TURN THE MILK FROTH
ADJUSTMENT DIAL TO
MILK POSITION
PLEASE DESCALE YOUR
MACHINE
REPLACE SOFTENER
FILTER
GENERAL ALARM: REFER
TO USER MANUAL
Possible cause
Too much coffee has been
used.
The hot water spout (B6) is
not inserted or is inserted
incorrectly
The milk container (B8) is
not inserted correctly.
The brewing unit (A2) has
not been replaced after
cleaning.
The water circuit is empty
Milk has been delivered
recently and the tubes inside
the milk container must be
cleaned.
The milk container has been in-
serted with the froth adjustment
dial in the CLEAN position.
The machine must be
descaled.
The softener filter (B4) is
exhausted.
The inside of the appliance
is very dirty.
Remedy
Select a milder taste or
reduce the quantity of pre-
ground coffee (maximum 1
measure).
Insert the water spout as
far as it will go.
Insert the milk container
as far as it will go (fig. 17
Quick Guide).
Insert the brewing unit as
described in the section
"Cleaning
the brewing unit".
Press OK to deliver water
from the spout (B6) until it
flows out normally. Delivery
stops automatically. If the
problem persists, make
sure the water tank (A6) is
fully inserted.
Turn the froth adjustment
dial to CLEAN.
Turn the dial to the required
froth position.
Press DESCALE to start
descaling
Press OK to replace or
remove the filter, or ESC
to carry out the procedure
later. Follow the instruc-
tions in section "Water
softener filter".
Clean the inside of the
appliance thoroughly, as
described in the section
"Cleaning". If the mes-
sage is still displayed after
cleaning, contact Customer
Services.
Advertisement
Table of Contents
