Water Softener Filter - AEG KKE994500 User Manual

13. WATER SOFTENER FILTER

Certain models are fitted with a softener
filter (B4). If this is not the case with
your model, you are recommended to
purchase one from Customer Services.
(cod. 9029798726 M3BICF200)
WebShop AEG: www.aeg.com/shop.
To use the filter correctly, follow the
instructions below.
13.1 Installing the filter
1. Remove the filter (B4) from its pack-
aging;
2. Turn the rotary (C2) to select "Menu",
then press the dial to confirm.
3. Select "Basic Settings", press to
confirm, select "Water" and confirm.
4. Select "Softener" and set On.
5. TURN DATE INDICATOR TO DIS-
PLAY NEXT 2 MONTHS
turn the date indicator disk until the
next two months of use are dis-
played. Press OK;
The filter lasts about two months if
the appliance is used normally. If
the coffee machine is left unused
with the filter installed, it will last a
maximum of 3 weeks.
6. RUN WATER INTO FILTER HOLE
UNTIL IT COMES OUT FROM
OPENINGS: To activate the filter, run
tap water through the hole in the filter
as shown in the figure until water
comes out of the openings at the side
for more than a minute. Press OK;
7. Extract the tank (A6) from the appli-
ance and fill with water.
8. IMMERSE FILTER IN THE WATER
TANK LETTING AIR BUBBLES
ESCAPE: Insert the filter in the water
tank and immerse it completely for
about ten seconds, sloping it and
pressing it lightly to enable the air
bubbles to escape. Press OK;
9. INSERT FILTER INTO ITS HOUS-
ING AND PUSH IT DOWN TO
BOTTOM: Insert the filter in the filter
housing and press as far as it will go.
Press OK;
10. INSERT WATER TANK: Close the
tank with the lid, then replace the
tank in the machine.
11. PLACE 0.5L CONTAINER UNDER
ENGLISH 21