Mixing; Assigning A Mix To A Switch - Spektrum SPMR8100 Instruction Manual

EN
FUNCTION LIST
The following menu options are only available when they are enabled from the Model Type screen.
V-Tail Differential 
Only available in Sailplane Type when V-Tail A or V-Tail B is active. See SAIL (Sailplane) section for set up.
Camber Preset 
Only available in Sailplane Type when a 2+ aileron wing type is selected. See SAIL (Sailplane) section for set up.
Camber System 
Only available in Sailplane Type when a 2+ aileron wing type is selected. See SAIL (Sailplane) section for set up.
Flap System
Only available in Airplane Type when a flap-enabled wing type is selected. See ACRO (Airplane) section for set up.

Pitch Curve
 Only available in Helicopter Type. See HELI (Helicopter) section for set up.
Swashplate
Only available in Helicopter Type. See HELI (Helicopter) section for set up.

Gyro
Only available in Helicopter Type. See HELI (Helicopter) section for set up.

Tail Curve
 Only available in Helicopter Type. See HELI (Helicopter) section for set up.
Motor Cut
Only available in Multicopter Type. See MULTI (Multicopter) section for set up.

Motor Curve
Only available in Multicopter Type. See MULTI (Multicopter) section for set up.


Mixing

Mixing allows control input for a channel to affect more than one
channel at a time. Mixing functions support:
• Mixing a channel to another channel.
• Mixing a channel to itself.
• Assigning offset to a channel.
• Linking primary to secondary trim.
These mixes are available for each model memory:
• 8 programmable mixes
• Cyclic to Throttle (HELI)
• Swashplate (HELI)
• Elevator to Flap (ACRO)
• Aileron to Rudder (ACRO)
Select a channel for master and slave. Inputs for the master
channel control both the master and slave channels. For example,
Elevator to Flap makes elevator the master channel and flap the
slave channel.

Assigning a Mix to a Switch

If you wish to assign a mix to a switch position:
1. Make sure you are in the desired mix screen.
2. Move the switch you want to assign the mix to.
3. Scroll to the switch position where you want the mix to be
active.
4. Press the scroll wheel to activate the mix. When the box is
filled, the mix is active.
The mix is Active when the box is filled and Inactive when the
box is open. You can assign a mix to be active in multiple switch
positions (0,1 or 2).
32
• Rudder to Aileron/Elevator (ACRO)
• Aileron>Rudder (SAIL)
• Aileron>Flap (SAIL)
• Elevator>Flap (SAIL)
• Flap>Elevator (SAIL)
Offset
Change the Offset value to move the effective center position
of the slave channel. Positive or negative value determines the
direction of the offset. Offset is not available for curve mixes.
Trim
If the master channel trim should also adjust the slave channel, set
Trim to Act. A channel monitor on the left side of the screen shows
how channels respond to input. To view a switch-assigned mix on
the monitor, the mix switch must be in the active position.
Tip: Use Auto Switch Select to select the switch.
CAUTION: Always do a Control Test of your model after
changing mixes.
SPEKTRUM DX8e • TRANSMITTER INSTRUCTION MANUAL