Table of Contents
Advertisement
EN
MAIN SCREEN
Function
Model Name
A
B
DSMX/DSM2 If not shown, this indicates not bound
Displays throttle position
C
Digital Battery Voltage (an alarm sounds and the screen flashes
D
when battery charge gets down to 6.4V for a LiPo/Li Ion battery.)
Model Avatar
E
Elevator Trim (Mode 2, 4)
F
Throttle Trim (Mode 1, 3)
Aileron Trim (Mode 1, 2)
G
Rudder Trim (Mode 3, 4)
H
Model Memory Timer
NAVIGATION
• Scroll the scroll wheel to move through the screen content or
change programming values. Press the scroll wheel to make
a selection.
• Use the Back button to go to the previous screen (for example,
to go from the Mixing Screen to the Function List).
• Use the Clear button to return a selected value on a screen to
the default setting.
• Direct Model Access enables you to access the Model Select
screen without powering off the transmitter. Anytime the
transmitter power is on, press the Clear and Back buttons to
access the Model Select screen.
Tip: The tick mark below shows the current switch position.
Rolling and clicking the scroll wheel turns the selected box black,
indicating that the value or condition will act on that position.
Auto Switch Select
To easily select a switch in a function, such as a program mix,
roll with the scroll wheel to highlight the switch selection box, and
press the scroll wheel. The box around the switch should now
flash. To select a switch, toggle the switch you wish to select.
Verify the switch selection is now displayed as desired. When
correct, press the scroll wheel to select this switch and complete
the switch selection.
8
Function
Rudder Trim (Mode 1, 2)
I
Aileron Trim (Mode 3, 4)
Throttle Trim (Mode 2, 4)
J
Elevator Trim (Mode 1, 3)
Timer
K
B
C
A
K
J
I
H
• Press and hold the scroll wheel while powering on the
transmitter to show the System Setup list. No radio
transmission occurs when a System Setup screen is
displayed, preventing accidental damage to linkages and
servos during changes to programming.
• At the main screen you can scroll to view the servo monitor.
• The Main Screen appears when you power on the transmitter.
Press the scroll wheel once to display the Function List.
• When you want to change a value in a screen for a particular
control position, move the control to the desired position to
highlight the value you want to change, such as 0/1/2, up/
down or left/right.
Press
Turn
Press
Scroll
Move between
Enter, Choose
or Exit
options or change
value in an option
SPEKTRUM DX8e • TRANSMITTER INSTRUCTION MANUAL
D
E
F
G
Press
Hold
Hold for 3
seconds and
release to move to
the Main Screen
Advertisement
Table of Contents
