Table of Contents
Advertisement
For tool with shallow bit hole
A=12mm
Use only these type of bit. Follow the
procedure (1).
B=9mm
(Note) Bit-piece is not necessary.
006348
For tool with deep bit hole
A=17mm
To install these types of bits, follow
the procedure (1).
B=14mm
To install these types of bits, follow
A=12mm
the procedure (2).
B=9mm
(Note) Bit-piece is necessary for
installing the bit.
011405
2
1
013580
1.
To install the bit, pull the sleeve in the direction of
the arrow and insert the bit into the sleeve as far
as it will go. Then release the sleeve to secure
the bit.
2
1
3
013581
2.
To install the bit, pull the sleeve in the direction of
the arrow and insert the bit-piece and bit into the
sleeve as far as it will go. The bit-piece should be
inserted into the sleeve with its pointed end facing
in. Then release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
1. Sleeve
2. Bit
1. Sleeve
2. Bit-piece
3. Bit
8
case, try re-inserting the bit according to the
instructions above.
OPERATION
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the
figures.
Hold the tool firmly and place the point of the driver bit
in the screw head. Apply forward pressure to the tool to
the extent that the bit will not slip off the screw and turn
the tool on to start operation.
Standard bolt BTD043
.
N m
25
20
15
10
M6
5
0
0
0.5
Fastening time
013683
High tensile bolt BTD043
.
N m
20
18
16
14
12
10
8
6
4
2
0
0
Fastening time
013681
M10
M10
M8
(M8)
(M6)
1
1.5
2
Seconds
M6
(M6)
2
1
Seconds
Advertisement
Table of Contents
