Overload Protection; Overheat Protection; Overdischarge Protection - Makita JV103D Instruction Manual

Hide thumbs Also See for JV103D:
Table of Contents

Advertisement

Overload protection

When the battery is operated in a manner that causes
it to draw an abnormally high current, the tool automat-
ically stops without any indication. In this situation, turn
the tool off and stop the application that caused the tool
to become overloaded. Then turn the tool on to restart.

Overheat protection

When the tool or battery is overheated, the tool stops
automatically and the lamp blinks. In this case, let the
tool and battery cool before turning the tool on again.

Overdischarge protection

When the battery capacity is not enough, the tool stops
automatically. If you turn the tool on, the motor runs
again but stops soon. In this case, remove the battery
from the tool and charge the battery.
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
► 1 . Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
1
2
Remaining
capacity
Off
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Selecting the cutting action
► 1 . Cutting action changing lever
This tool can be operated with an orbital or a straight
line (up and down) cutting action. The orbital cutting
action thrusts the jig saw blade forward on the cutting
stroke and greatly increases cutting speed.
To change the cutting action, just turn the cutting action
changing lever to the desired cutting action position.
Refer to the table to select the appropriate cutting
action.
Position
0
I
II
III
Switch action
To turn on the tool, press the lock/unlock button. The
tool turns into the standby mode. To start the tool, pull
the switch trigger in the standby mode. To stop the
tool, release the switch trigger. The tool turns into the
standby mode. To turn off the tool, press the lock/unlock
button in the standby mode.
For continuous operation, pull the switch trigger in the
standby mode, and then push in the lock on button.
To stop the tool, pull the switch trigger fully, and then
release it.
6 ENGLISH
1
Cutting action
Applications
Straight line cutting
For cutting mild
action
steel, stainless
steel and plastics.
For clean cuts in
wood and plywood.
Small orbit cutting
For cutting mild
action
steel, aluminum
and hard wood.
Medium orbit
For cutting wood
cutting action
and plywood.
For fast cutting in
aluminum and mild
steel.
Large orbit cutting
For fast cutting in
action
wood and plywood.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jv103dz

Table of Contents