Collect Tools; Collect Additional Hardware For Installation - Cisco MR74 Hardware Installation Manual

Table of Contents

using a Meraki PoE Injector, connect the MR74 to the "PoE" port of

the Injector, and the client machine to the "LAN" port.

2. Using a web browser on the client machine, access the AP's built-in web

server by browsing to http://ap.meraki.com. Alternatively, browse to

http://10.128.128.128.

3. Click on the "Static IP Configuration" tab. Log in. The default user name

is the AP's serial number, with hyphens included (e.g., Q2BD-551C-

ZYW3), and the default password is blank.

4. Configure the static IP address, net mask, gateway IP address and DNS

servers that this AP will use on its wired connection.

5. If necessary, reconnect the AP to the LAN.

3.5 Collect Tools

You will need the following tools to perform an installation:

- Flat-head screwdriver

- Drill with appropriate bits for mounting wall anchors (if mounting to a

wall)

- Phillips screwdriver

Tin snips (if mounting with hose clamps)

- Power screwdriver with 5/16" (8 mm) nut driver, Phillips & flat heads

(recommended)

- Network cables with RJ45 connectors long enough for your particular

mounting location

- 802.3af PoE power source (either PoE switch or Meraki 802.3af PoE

Injector)

Table of Contents