Table of Contents
Advertisement
31/01/2022, 19:00
Static Assignment
Static IPs are assigned using the local web server on each AP. The following procedure describes how to set the
static IP:
1. Using a client machine (e.g., a laptop), connect to the AP wirelessly (by associating to any SSID broadcast by
the AP) or over a wired connection.
2. If using a wired connection, connect the client machine to the MR36H either through a PoE switch or a PoE
Injector. If using a PoE switch, plug an Ethernet cable into the MR36H's Ethernet jack, and the other end into
a PoE switch. Then connect the client machine over Ethernet cable to the PoE switch. If using a PoE Injector,
connect the MR36H to the "PoE" port of the Injector, and the client machine to the "LAN" port.
3. Using a web browser on the client machine, access the AP's built-in web server by browsing to
http://my.meraki.com. Alternatively, browse to http://10.128.128.128.
4. Click on the "Uplink Configuration" tab. Log in. The default login is the serial number (e.g. Qxxx-xxxx-xxxx),
with no password (e.g., Q2DD-551C-ZYW3).
5. Configure the static IP address, net mask, gateway IP address and DNS servers that this AP will use on its
wired connection.
6. If necessary, reconnect the AP to the LAN.
Static IP via DHCP Reservations
Instead of associating to each Meraki AP individually to configure static IP addresses, an administrator can
assign static IP addresses on the upstream DHCP server. Through "DHCP reservations, " IP addresses are
"reserved" for the MAC addresses of the Meraki APs. Please consult the documentation for the DHCP server to
configure DHCP reservations.
Collect Tools
You will need the following tools to perform an installation:
Collect Additional Hardware for Installation
How can we help you?
You will need the following hardware to perform an installation:
https://documentation.meraki.com/MR/MR_Installation_Guides/MR36H_Installation_Guide
MR36H Installation Guide - Cisco Meraki
10/21
Advertisement
Table of Contents
