Cisco MR74 Hardware Installation Manual page 9

4.2 Install the MR74
For most mounting scenarios, the MR74 mount plate provides a quick,
simple, and flexible means of mounting your device. The installation
should be done in two steps. First, install the mount plate to your selected
location. Then attach the MR74 to the mount plate.
4.2.1 Remove the Mount Plate from the Access Point
Before installing the mount plate, you must remove it from the back of the
access point.
1. Unscrew the mount plate attachment screw.
2. Lift the mount plate release tab upwards.
3. While holding the mount plate release tab up, slide the mount plate off
the access point.
4.2.2 Attach the Mount Plate
The MR74 mount plate can be used to install your access point in a wide
range of scenarios.
4.2.2.1 Wall or Solid Ceiling Mount Using Mount Plate
Using included wall anchors and screws, attach the mount plate to your
mounting wall or ceiling.
It is recommended that the MR74 be mounted to a wall or solid ceiling
using the mount plate for physical security reasons.
4.2.2.2 Pole Mount Using Mount Plate
Use the included mounting straps to mount the AP to a pole less than 3.9"
in diameter. Thread the mounting straps through the mounting strap slots
to secure the mount plate in a horizontal or vertical orientation.
4.2.3 Mount the MR74
Insert the posts on the mount plate into the attachment slots on the access
point.
4.2.3.1 Attach Antennas