Table of Contents
Advertisement
CAUTION:
Always lock the trigger, disconnect the hose and
•
remove the nails from the magazine before
cleaning a jam.
When the nailer becomes jammed, do as follows:
Open the magazine cap and remove the nail coil. Insert a
small rod or the like into the ejection port and tap it with a
hammer to drive out the nail jamming from the ejection
port. Reset the nail coil and close the magazine cap.
Hook
1
005723
The hook is convenient for hanging the tool temporarily.
This hook can be turned by hand to the desired angle of
the tool.
CAUTION:
Always lock the trigger and disconnect the hose
•
when hanging the tool using the hook.
Never hang the tool on a waist belt or like.
•
Dangerous accidental firing may result.
005724
Nails
Nail
004310
Handle nail coils and their box carefully. If the nail coils
have been handled roughly, they may be out of shape or
their connector breaks, causing poor nail feed.
Avoid storing nails in a very humid or hot place or place
1. Hook
8
exposed to direct sunlight.
Humid
Nail
004311
MAINTENANCE
CAUTION:
Always disconnect the air hose from the tool before
•
attempting to perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Maintenance of nailer
Always check the tool for its overall condition and loose
screws before operation. Tighten as required.
005725
Make sure all safety systems are in working order before
operation. The tool must not operate if only the trigger is
pulled or if only the contact element is pressed against
the wood. It must work only when both actions are
performed. Test for possible faulty operation with nails
unloaded.
005726
Hot
Advertisement
Table of Contents
