Basic Operations; Connect The Power Cord; Turn On The Main Power; Turn On The Lamp Power - Sharp XG-NV5XE Operation Manual

Basic Operations

Projector
3
5
4

1 Connect the Power Cord

Plug the supplied power cord into the AC socket on the
back of the projector.
1

2 Turn on the Main Power

Press the MAIN POWER switch on the back of the
projector. The POWER indicator lights up red and the
projector enters standby mode.
2
• If the bottom filter cover is not securely installed, the POWER
indicator flashes.
• When the main power is not on, the "Power" remote control
cannot be used.
When the main power is on, the POWER indicator lights up
red.

3 Turn on the Lamp Power

Press POWER ON on the projector or the "Power"
VOL
ON
remote control.
MUTE
OFF
BLACK
SCREEN LASER
TOOLS MENU
• The flashing green LAMP REPLACEMENT indicator shows
that the lamp is warming up. Wait until the indicator stops
flashing before operating the projector.
• If the power is turned off and then immediately turned on
again, it may take a short while before the lamp turns on.
• After the projector is unpacked and turned on for the first
R-CLICK ENTER
time, a slight odour may be emitted from the exhaust vent.
INPUT IrCOM
This odour will soon disappear with use.
FREEZE AUTO SYNC
When the power is on, the LAMP REPLACEMENT indicator
lights indicating the status of the lamp.
Green: Lamp is ready.
Flashing green: Warming up.
Red: Change the lamp.

4 Adjusting Focus

Slide the focus knob until the image on the screen
becomes clear.

5 Adjusting Zoom

Slide the zoom knob. The image can be adjusted to the
desired size within the zoom range.
18