Set up your TV Settings assistant Picture and sound Channels Menu language Set universal access Other settings Update software Reinstall the TV Connect your TV About cables Connect devices Connect more devices Computers and the Internet Common interface Troubleshooting Contact Philips General TV...
1 Get started TV tour Remote control To open or close the Find menu. In the Find menu, access the channel list. To adjust the volume. To open or close the Adjust menu. In the Adjust menu, access a range of frequently used settings.
Press and hold to return to watching TV. Press to select the next TV tour. Connect devices To exit from menu or TV function. To select a red menu option, access Digital Interactive TV services*, or watch TV demonstration clips. *Available on certain models only.
Page 5
TV. Net TV offers movies, pictures, music setup menu. and much more. For more information about the availability Read more in Use your TV > Browse Net of HD channels in your country, contact TV (Page 21). your Philips dealer or visit www.philips.com/support.
When stand mounting the TV, use only the power outlet immediately. Contact the supplied stand. Secure the stand to Philips Consumer Care to have the TV the TV tightly. Place the TV on a flat, checked before use. level surface that can support the ...
Always leave a space of at least 4 Energy efficiency inches or 10 cm around the TV for ventilation. Ensure that curtains or Philips continuously focuses on lowering the other objects never cover the environmental impact of our innovative ventilation slots on the TV.
Energy saving picture settings: You can When this crossed-out wheeled bin symbol apply a combination of energy saving is attached to a product it means that the picture settings. While you watch TV, product is covered by the European press the green button and select Directive 2002/96/EC.
TV mounting that results in accident, injury or damage. Before you mount the TV: Purchase a Philips TV mount or a compatible TV mount. For certain models, remove the wall mount plugs from the back of the TV.
(available in certain countries only) Contact Philips If you like, you can contact Philips Consumer Care in your country for support. You can find the contact number in the leaflet accompanying the TV.
2 Use your TV Indicators Controls TV controls 1. Ambient sensor / remote control sensor Ambient sensor is available on certain models only. Remote control +/-: Increase or decrease volume. 2. AMBILIGHT: Switch Ambilight on or off. Ambilight is available on certain models only. (Home): Access the Home menu.
Page 12
4. (Home): Access the Home menu. Caution: The battery contains perchlorate (Navigation buttons): Navigate material, handle it with care. For information, through menus and select items. 6. CH - / CH + (Previous/Next): Switch www.dtsc.ca.gov/hazardouswaste/perchlorat channels, navigate through menu pages, tracks, albums or folders.
You can also view a slideshow of the images in your smartphone on the TV. To download the application 'Philips My Remote', visit the Apple Apps store or the Android Market. Follow the instructions provided at the applications store.
+/- on the front of the TV. Press If the TV is in standby, press on the remote control. Note: There is a short delay before the TV responds. Tip: If you cannot find your remote control and want to switch on the TV from standby, press CH +/- on the front of the TV.
Note: TV programme guides are available in Manage channel lists certain countries only. You can view all channels or only your Set programme guide favourite channels in the channel list. Before you use the programme guide, check FIND. The While you watch TV, press the following settings: channel list is displayed.
[Personal]: Apply your personalised [Auto zoom]: Enlarge the picture to fill picture settings. the screen. Recommended for minimal [Vivid]: Rich and dynamic settings, ideal screen distortion but not for HD or PC. for daytime viewing. [Super zoom]: Remove the black bars ...
Page 17
After you have added the new device to the Watch video Home menu, select the new device icon to Press the Navigation buttons to select a view its contents. video file, then press OK. 1. Press . Press to search forward or 2.
You can also press AMBILIGHT on the TV [Shuffle off] / [Shuffle on]: Enable or to switch Ambilight on or off. disable random display of pictures in the slideshow. [Slideshow speed]: Set the display time for each picture in the slideshow. ...
Play (uPnP) router. Music, My Pictures, and My Videos. A Philips wireless USB adapter or a 4. If your files are in other folders, select LAN cable that connects your TV to Library > Add to Library, and then follow your home network.
Page 20
4. Type a name for your media server, and Enable sharing on Windows Media then click Save changes. Player 12 5. Back in the Twonky Media screen, select 1. Start Windows Media Player on your Basic Setup > Sharing. computer. 6.
Access Net TV Applications (Apps) 2. On your TV, configure Net TV. The first page shown is the Net TV home 3. On your PC, register with Philips to enjoy page. The icons on this page represent the exclusive benefits and receive updates on applications (Apps).
OPTIONS and select [Show Press Browse Internet websites with the remote control]. Use the onscreen keys to Internet Apps. Press the Navigation buttons to select operate the connected audio or video an App, then press OK to confirm. player. ...
Page 23
SD memory size Rent Use a blank SD memory card of type SDHC View a video store class 6, with at least 4 GB of storage 1. Press . capacity. 2. Select [Browse Net TV] and press OK. For high-definition video, make sure that you 3.
Watch video To find out what interactive services are 1. Press , select [Browse Net TV]. available, contact your broadcasters. The installed video stores are displayed. Access application 2. Select the video store where you rented the video, then press OK. 1.
3 Use more of Do not overload the USB port. If you connect a USB hard disk device that your TV consumes more than 500 mA power, ensure that it is connected to its own external power supply. Once the USB hard disk device is Pause TV formatted for this TV, you cannot use it...
Pause a live TV broadcast Start a programme recording. Switch the TV to standby. Switch to another channel. Switch source to watch from a connected device - a Blu-ray disc player or digital receiver. To change playback speed Press repeatedly.
Page 27
Note: If you are using a USB hub, do not To check if the programme guide supports recording: connect any other USB device to the TV when you are formatting the USB hard disk. and select [Programme guide]. If Press you find a [TV Recording] button on the programme guide page, you can set up and manage recordings.
Page 28
Set a timed recording If your TV remote control does not have a To manually set a recording that is not linked button: to any programme: and select [Programme guide]. 1. Press 1. From the programme guide page, press 2. With the current TV programme selected, OPTIONS, select [Manual record], and press OPTIONS and select [Record].
1. Select the recording in the list and press Access HbbTV OPTIONS. When you tune to a TV channel that offers 2. Select [Delete recording] and press OK. HbbTV, the interactive pages will open Cancel a scheduled recording automatically or, at some point, you will be invited to open them.
To switch Teletext 2.5 on or off 1. In the [Clock] menu, select [Date] or [Time], then press OK. 1. Press . 2. Select [Setup] > [TV settings] > 2. Use the Navigation buttons to make your [Preferences]. selection. 3. Select [Text 2.5] > [On] or [Off], then 3.
Parental rating Subtitle language Some digital broadcasters rate their You can change the subtitle language on programmes according to age. You can set some digital channels. your TV to display only programmes with 1. Press . age ratings lower than your child's age. 2.
Philips EasyLink. You can hear a connected HDMI-CEC compliant device through the TV speakers, After you switch on Philips EasyLink, these even when the TV is in standby. features are available: To switch on, see Use more of your TV >...
Page 34
To switch on or off EasyLink : Display the TV menu. Note: If you do not intend to use Philips (Standby): Switch the TV and the Easylink, switch it off. connected device to standby. 1. Press .
Page 35
ADJUST to receive audio from 1. Press [TV]: On by default. the connected Philips EasyLink device. Stream TV audio through the TV and If available, audio only mode is enabled. the connected HDMI-CEC audio 2. Accept the prompt on the TV to turn off device until the connected device the TV screen.
4 Set up your TV [Pixel Plus HD] / [Pixel Precise HD]: Access advanced settings, including [HD Natural Motion], [Clear LCD]*, [Advanced sharpness], [Dynamic Settings assistant contrast], [Dynamic backlight], [MPEG artefact reduction], [Colour enhancement], [Gamma]. Use the settings assistant to guide you through the picture and sound settings.
Audio settings Channels Select audio language If the TV channel has multiple or dual sound Reorder and rename broadcast, you can select the preferred audio language. Reorder channels OPTIONS. While you watch TV, press After the channels are installed, you can ...
Update channel list 4. Select one of the following settings: [Antenna (DVB-T)]: Access free-to-air When the TV was switched on for the first time, a full installation of channels was antenna or digital DVB-T channels. [Cable]: Access cable or digital DVB-C performed.
ATTENTION: This feature is intended for mode] unless your cable provider dealers and service personnel. supplies you with a specific symbol rate You can copy channel lists from one Philips value. TV to another through a USB storage Install satellite channels device.
4. If the country setting on the TV is different the same hardware type, as indicated from that of the TV whose channel list you by the sticker on the back of the TV, want to copy, reinstall the TV and select the (for example Qxxx.xx.Lx), and country setting to match the first TV.
To switch on hearing impaired audio and Audio feedback for the visually impaired subtitles This feature enables audio feedback when OPTIONS. 1. While you watch TV, press buttons are pressed on the remote control 2. Press one of the following buttons to or TV.
Page 42
> [Setup] > [Update software], 1. Press www.philips.com/support. then press OK. 4. At the Philips Support site, find your 2. Select [Internet], then press OK. product and locate the [Help] file for your 3. Follow the onscreen instructions to start TV.
If an error occurs during the update, retry the procedure. If the error reoccurs, contact Philips Consumer Care. 1. Switch on the TV. 2. Disconnect all other USB devices from the 3. Connect the USB storage device containing the *.upg file to the USB...
5 Connect your Do not use an HDMI cable longer than 5 meters / 16.4 feet. About cables Cable quality Overview Before you connect devices to the TV, check the available connectors on the device. Connect the device to the TV with the highest quality connection available.
SCART A SCART cable combines video and audio Use this connection to display PC content signals. on the TV. SCART connectors can handle RGB video For video and sound, use the VGA and signals but cannot handle high-definition AUDIO IN connectors. (HD) TV signals.
Page 46
Blu-ray or DVD disc player Connect the disc player with an HDMI cable to the TV. Connect the disc player with a component cable (Y Pb Pr) and an audio L/R cable to the TV. TV receiver Connect the satellite or digital TV receiver with an antenna cable to the TV. (SAT is available on certain models only.)
Page 47
Connect the satellite or digital TV receiver with an HDMI cable to the TV. Connect the satellite or digital TV receiver with a SCART cable to the TV. Connect the satellite or digital TV receiver with a component cable (Y Pb Pr) and an audio L/R cable to the TV.
Page 48
Recorder Connect the recorder with an antenna cable to the TV. (SAT is available on certain models only.) Connect the recorder with a SCART cable to the TV. Connect the recorder with a component cable (Y Pb Pr) and an audio L/R cable to the TV. For the best gaming experience, set the TV Game console to game mode.
Page 49
Connect the game console with an HDMI cable to the TV. Connect the game console with a component cable (Y Pb Pr) and an audio L/R cable to the TV. Home theatre system Connect the home theatre with an HDMI cable and an audio cable to the TV.
Page 50
Connect the home theatre with a SCART cable to the TV. Connect the home theatre with a component cable (Y Pb Pr) and an audio L/R cable to the TV. Digital camera Connect the digital camera with a USB cable to the TV.
Digital camcorder Connect the digital camera with an HDMI cable to the TV. Connect the digital camcorder with a component cable (Y Pb Pr) and an audio L/R cable to the TV. Connect more devices External hard disk Connect the external hard disk with a USB cable to the TV.
Page 52
Computer Connect the computer with an HDMI cable to the TV. Connect the computer with a DVI-HDMI cable to the TV. Connect the computer with a VGA cable and an audio cable to the TV. To install the USB keyboard Keyboard and mouse Switch on the TV.
If you have selected a Cyrillic or Greek Once the TV detects the mouse, set the keyboard layout first, you can also add a tracking speed. Navigate into the test area to second keyboard with Latin layout. check the speed. To use the USB mouse with your TV To change the keyboard layout setting, press >...
Page 54
Wireless LAN ready A computer network that includes: a) A universal plug-and-play (UPnP) This section is only for wireless ready TVs. router and With the Wireless USB adapter PTA01 b) A computer with one of these accessory (sold separately), you can connect operating systems: Microsoft Windows the TV to your home network wirelessly.
Page 55
For the availability of the wireless USB where to enter the PIN code. adapter, check with your local retailers or Custom buy online at www.philips.com/tv. Install Wi-Fi MediaConnect (with CD- To enter the encryption key (the security key) manually, select [Custom] and press ROM) OK.
3. Enter the code printed on the CD-ROM 200 MB free hard disk space envelope. Wi-Fi 802.11g 4. Click the 'Download now' button to Internet connection download the free Wi-Fi MediaConnect Project your PC: PC requirements software. 5.
Page 57
1. Switch off the TV. 2. Follow the directions printed on the CAM and insert the CAM into the Common Interface at the side of the TV. 3. Push the CAM in as far as it will go, then wait for the CAM to be activated. This takes a few minutes.
TV chassis: this TV at www.philips.com/support. No action is required. The creaking sound is You can also contact Philips Consumer Care due to the normal expansion and in your country for support. You can find the contraction of the TV as it cools and warms contact number in the leaflet that up.
Make sure that the correct device is An "e-sticker" banner displaying selected as the display source. information appears on the TV display: Make sure that the external device or The TV is in [Shop] mode. To remove the source is properly connected.
HDMI Audio and picture files do not play or display smoothly: There are problems with HDMI devices: The transfer performance of the USB storage device may limit the data transfer Note that HDCP (High-bandwidth rate to the TV which causes poor playback. Digital Content Protection) support can delay the time taken for a TV to display content from a HDMI device.
For power consumption, see the Clear Sound product specifications at Dynamic Bass Enhancement www.philips.com/support. Mono / Stereo / NICAM The power rating stated on the product typeplate is the power consumption for this product during normal household use (IEC Display resolutions 62087 Ed.2).
SERV.U: Service port Dimensions AUDIO IN: DVI/VGA stereo 3.5-mm mini-jack Note: Dimensions and weights are SAT (DVB-S): Available on certain approximate values only. Design and models only. specifications are subject to change without Bottom notice. Network: Ethernet Legend for TV dimensions ...
Use your TV legend to note the dimensions of your TV (with and without the stand). Use your TV legend to note the thickness of your TV (with and without the stand). Help version UMv 3139 137 04194- 2012 0402...