Additional Features - Whirlpool WET4024EW0 Use And Care Manual

4.
Select End of Cycle Signal
(optional, on 27" models only)
Your dryer may have an End of Cycle Signal. The signal is
helpful when drying items that should be removed from the
dryer as soon as it stops. On the PUSH TO START button,
turn the END OF CYCLE SIGNAL selector to ON or OFF.
The signal will sound only if the selector is set to ON.
NOTE: When the Tumble Press
the End of Cycle Signal is on, the tone will sound every
5 minutes until the clothes are removed or the Tumble Press
setting ends.
5.
Press PUSH TO START knob
to begin cycle
27" Models
Push and hold the PUSH TO START knob to begin the cycle.
Promptly remove garments after cycle has completed to reduce
wrinkling. Use the Tumble Press
when you are unable to remove a load from the dryer as soon
as it stops.
setting is selected and
®
24" Models
feature to avoid wrinkling
®

Additional Features

USING THE DRYING RACK
To obtain a drying rack for your dryer, follow the instructions
included in your dryer drum. Remove and discard any
packing material before use.
Use the drying rack for items that you do not want to tumble
dry, such as sweaters and tennis shoes. When you use the
drying rack, the drum continues to turn, but the rack remains
stationary.
The drying rack is intended for use with the Timed Drying
cycles only. The drying rack cannot be used with Automatic
Dry cycles.
To use the drying rack:
IMPORTANT: Do not remove the lint screen.
1. Open dryer door.
®
2. Align the two hooks on the front of the drying rack with
the holes in the dryer door opening and press down fully
into holes. Rest the rear support on the dryer back ledge.
3. Place wet items on top of the drying rack. Allow space
around items for air to circulate. The drying rack does
not move, but the drum will rotate. Make sure items do
not hang over the edges or between drying rack grille.
4. Close the door.
5. Select a Timed Drying/Fluff Air or Low Temperature
cycle. Items containing foam, rubber, or plastic must be
dried on a clothesline or by using the Fluff Air setting.
6. Start the dryer.
NOTE: Check the lint screen and remove any lint
accumulated from items dried on the drying rack
after the cycle is finished.
13