Table of Contents
Advertisement
Before you begin
Before installing your ADSL wireless modem router, please carefully check the following
requirements with your computer. This ADSL wireless modem router is equipped with four
10/100Mbps RJ-45 Ethernet switch ports and 802.11g wireless Access Point. You can connect to the
modem by Ethernet or wireless interface.
Unpacking and Inspection
Verify following items came with your ADSL Modem:
AAM6020VI unit
RJ-11 ADSL phone cable
RJ-45 UTP cable
Quick Installation Guide
Power adapter and splitter
Note: If any items are missing or damaged, please contact your local Sales Office for service.
System Requirements
IBM compatible, Macintosh or other OS-independent workstation supports TCP/IP.
An Ethernet port supports 10Mbps or 10/100Mbps TCP/IP connection on your PC.
For system configuration using the supplied web-based program: a web browser such
as Internet Explorer v5.5 or later
A wireless interface has installed properly on your PC, and it must support IEEE
802.11b or 802.11g wireless standard interface.
You can connect any one of modem four switch ports on the rear panel to PC NIC
Ethernet port. If you want to allow multiple computers (more than four PCs) to enjoy
internet through ADSL Modem, please purchase a hub/switch to link directly to
Ethernet port. You can contact your internet service provider to get more information
on this.
Caution:
1. If you want to use private Ethernet UTP cable linking between wireless modem
router with PC, please make sure that cable quality must conform to Cat.5
upward and cable's length can't exceed over 100 meters.
2. Please make sure that wireless modem router's wireless signal could be accessed
by wireless interface on PC, and without any interference by electromagnetic
wave device or obstacle around the corner.
AAM6020VI ADSL Wireless Modem Router Quick Installation Guide
2
Page
Advertisement
Table of Contents
