Bush BFSNB12B Instruction Manual page 25

Using your Dishwasher
Getting the most from your appliance
Before using the appliance
Detergent usage
Only use detergents specifically designed for
domestic dishwashers.
Add the recommended amount of detergent for the
selected programme to ensure the best
performance.
Keep your detergents in cool, dry places out of
reach of children.
See the detergent manufacturer's instructions for a
further information.
Filling the detergent
Push the latch to open the dispenser and
pour in the detergent.
Close the lid and press it until it locks in place. The
dispenser should be refilled just before the start of
each programme. If the dishes are heavily soiled,
place additional detergent in the pre-wash detergent
chamber.
Using combined detergents
These products should be used according to the
manufacturer's instructions.
Never put combined detergents into the interior
section or the cutlery basket.
Combined detergents contain not only the
detergent but also rinse-aid, salt replacement
substances and additional components depending
on the combination.
We recommend you do not use combined detergents
in short programmes.
Please use powder detergents in such programmes.
If you encounter problems when using combined
detergents, please contact the detergent
manufacturer.
e any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
If y ou requir
or online at If you still require further assistance, call one of our experts on
When you stop using combined detergents, make
sure that water hardness and rinse aid settings are
set to correct level.
Rinse-aid usage
Rinse-aid makes dishes sparkle and helps them to
dry without spotting. Rinse-aid is required for stain-
free utensils and clear glasses. Use only rinse-aid for
domestic dishwashers.
Filling the rinse-aid and setting
To fill the rinse aid compartment, open the
rinse-aid compartment cap. Fill the compartment
with rinse aid to the MAX level and then close
the cap. Be careful not to overfill the rinse aid
compartment and wipe up any spills.
In order to change the rinse aid level, follow
the below steps before turning on the
machine:
• Push the programme button and hold it
down.
• Turn on the machine.
• Hold down the programme button until "rA"
disappears from the display. Rinse aid setting
follows water hardness setting.
• The machine will display the last setting.
• Set the level by pushing the programme
button.
• Switch off the machine to save the setting.
• The factory setting is "4".
If the dishes are not drying properly or are
spotted, increase the level. If blue stains form on
your dishes, decrease level.
Level Brightener Dose
1 Rinse-aid not
dispensed
2 1 dose is
dispensed
3 2 doses are
dispensed
4 3 doses are
dispensed
5 4 doses are
dispensed
.
Using your Dishwasher
Indicator
r1 is shown on the
display.
r2 is shown on the
display.
r3 is shown on the
display.
r4 is shown on the
display.
r5 is shown on the
display.
25