Bush BFSNB12B Instruction Manual page 15

Installing your Dishwasher
Bringing it all together
Positioning your Dishwasher
When positioning the machine, place it in
an area where dishes can be easily loaded
and unloaded. Do not put the machine in an
area where the ambient temperature falls
below 0°C..
Read all warnings located on the packaging
before removing the packaging and
positioning the machine.
Place the machine close to a water tap
and drain. Take into consideration that the
connections will not be altered once the
machine is in position.
Do not hold the machine by its door or
panel.
Leave an adequate distance around the
machine to allow ease of movement when
cleaning.
Ensure the water inlet and outlet
hoses are not squeezed or trapped
and that the machine does not stand on the electrical
cable while positioning.
Adjust the feet so the machine is level and
balanced. The machine should be placed
on flat ground otherwise it will be unstable
and the door of the machine will not close
properly.
Water connection
We recommend fitting a filter to your water
inlet supply in order to prevent damage to
your machine due to contamination (sand,
rust, etc.) from indoor plumbing. This will
also help prevent yellowing and deposit
formation after washing.
e any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
If y ou requir
or online at
Installing your Dishwasher
15
If you still require further assistance, call one of our experts on
Water Inlet Hose
WARNING: Use the new water inlet hose
supplied with your machine, do not use an old
machine's hose.
WARNING: Run water through the new hose
before connecting.
WARNING: Connect the hose directly to the
water inlet tap. The pressure supplied by the tap
should be a minimum of 0.03MPa and a maximum
of 1 MPa If the pressure exceeds 1MPa, a pressure
relief valve must be fitted between the connection.
WARNING: After the connections are made,
turn the tap on fully and check for water leaks.
Always turn off the water inlet tap after a wash
program has finished.
An Aquastop water spout is available with
some models. Do not damage it or allow it to
become kinked or twisted.
.