Bush BFSNB12B Instruction Manual page 24

Using your Dishwasher
Getting the most from your appliance
Before using your appliance
Preparing your Dishwasher for first use
Check whether the electricity and supply water
specifications match the values indicated in the
installation instructions for the machine.
Remove all packaging materials inside the machine.
Set the water softener level.
Fill the rinse aid compartment.
Fill the salt (If Available)
To fill with softener salt, open the salt compartment
cap by turning it counter clockwise. (1) (2) At first use,
fill the compartment with 1 kg salt and water (3) until it
is almost overflowing. If available, using the funnel (4)
provided will make filling easier. Replace the cap and
close it. After every 20th-30th wash, add salt into your
machine until it fills up (approx. 1 kg).
1
3
Fill the salt compartment with water the first time you
fill the salt compartment only.
Use softener salt specifically produced for use in
dishwashers.
When you start your dishwasher, the salt compartment
is filled with water, therefore put the softener salt in
prior to starting your machine.
If the softener salt has overflowed and you do not start
the machine immediately, run a short washing
program to protect your machine against corrosion.
e any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
If y ou requir
or online at
Using your Dishwasher
24
2
4
If you still require further assistance, call one of our experts on
Test Strip
Run water Keep the
Shake
strip in
through tap
the strip.
(1min.) water(1sec)
NOTE: Level is set 3 as default. If the water is
well water or has a hardness level above 90
dF, we recommend that you use filter and
refinement devices.
Water Hardness Table
French
German
Level
dH dF
1 0-5 0-9
2 6-11 10-20
3 12-17 21-30
4 18-22 31-40
5 23-34 41-60
6 35-50 61-90
Water Softener System
The dishwasher is equipped with a water softener
which reduces the hardness in the mains water
supply. To find out the hardness level of your tap
water, contact your water company or use the
test strip (if available)
Setting
• Push the programme button and hold it down.
• Turn on the machine.
• Hold down the programme button until the
"SL" disappears.
• The machine will display the last setting.
• Set the level by pushing the programme
button.
• Switch off the machine to save the setting.
.
Set the hardness
Wai
level of your
(1min.)
t
machine.
1
2
3
4
5
6
British
Indicator
dE
0-6 L1 is shown on display.
7-14 L2 is shown on display.
15-21 L3 is shown on display.
22-28 L4 is shown on display.
29-42 L5 is shown on display.
43-63 L6 is shown on display.