Electro-Voice ETX-12P User Manual page 29

SUBWOOFER Menu
The Subwoofer menu is used to select a high pass frequency for use with a subwoofer or a
matched subwoofer. Available options for this selection are: OFF, 80Hz, 100Hz, 120Hz, 150Hz,
ETX-15SP, and ETX-18SP. The high passes are 24 dB/octave Linkwitz/Riley crossovers. The 80
Hz, 100 Hz, 120 Hz, and 150 Hz choices are generic high pass settings for use with other
subwoofers. The ETX-15SP and ETX-18SP settings are specifically optimized for subwoofers by
including delay for best summation.
The default is OFF.
ROOM EQ Menu
The Room EQ menu is a 3-band EQ (Equalizer) the user can fine tune beyond the FUNCTION
and LOCATION. Available options for this selection are: PEQ1, PEQ2, and PEQ3.
PEQ1,
PEQ2,
PEQ3:
Notice!
The Room EQ range shown is the factory default range with a stand alone loudspeaker. When
a subwoofer is selected, any EQ below the crossover point will be bypassed.
To use the EQ above the crossover point, do the following:
> Rotate the encoder to the desired frequency.
The BYPASS will be removed.
DELAY Menu
The Delay menu is used to create time alignment with other loudspeakers. Available options
for this selection are: NONE or a delay up to 343 m. The delay can be changed in 0.25 meter
increments. If the unit of measure is feet, available options for this selection are: NONE or a
delay up to 1125 ft. The delay can be changed in one (1) foot increments.
The default is NONE.
OPTIONS Menu
The Options menu is used to configure the DSP menu, LCD screen, and system. You can also
configure the accessibility of the menu as well as reset the modified settings to factory
default.
BACK Menu
The Back menu is used to return to the main menu.
FRONT LIGHT Menu
The Front Light menu shows power on and indicates limit. Available options for this selection
are: ON, OFF or LIMIT.
▪
▪
Electro-Voice
ETX-10P Range: 60 Hz – 20.0 kHz
ETX-12P Range: 50 Hz – 20.0 kHz
ETX-15P Range: 45 Hz – 20.0 kHz
ETX-35P Range: 40 Hz – 20.0 kHz
ON – turns the LED on when the power to the loudspeaker is ON. (Default)
OFF – turns the LED off.
BACK
Default: 0 dB
Range: -12 dB – +6 dB
Q: 1.2
User Manual
en 29
2016.04 | 05 | F.01U.276.083