Specifications - IMG STAGELINE PAK-8XC Instruction Manual

5 Operation
GB
CAUTION Never adjust a very high volume. Per-
manent high volumes may damage
your hearing! The human ear will get
accustomed to high volumes which
do not seem to be that high any more
after some time. Therefore, do not
further increase a high volume after
getting used to it.
Note: To prevent switching noise, always switch on
the active speaker system after the signal
source connected and after use switch it off
first.
1) Set the control LEVEL (4) to minimum (left stop)
for the time being and switch on the amplifier
with the POWER switch (9). The LED ON (7)
lights up.
2) Adjust the desired volume with the control
LEVEL (4). Only turn up the control to such an
extent that the sound reproduced will not be dis-
torted. If the overload CLIP (8) lights up, turn
back the control accordingly.
If a microphone is connected, add its signal
with the control MIC LEVEL (3). The control
LEVEL (4) will define the overall volume.
CAUTION! To prevent a howling noise, do not
hold the microphone in the direction of the
speaker or too close to it. If a volume has been
adjusted too high, a howling noise may occur as
well. In this case adjust a lower microphone vol-
ume with the control MIC LEVEL (3).
3) After use, always switch off the speaker system
with the POWER switch.
All rights reserved by MONACOR
may be reproduced in any form or by any means for any commercial use.
10
6
Amplifier power
Frequency range: . . . . . . . . 60 – 20 000 Hz
Max. rated SPL: . . . . . . . . . . 111 dB
Inputs (sensitivity/ max. input voltage/ impedance)
Output LINE OUT, XLR
Pin configuration of the XLR connections:
Power supply: . . . . . . . . . . . 230 V~/50 Hz
Power consumption: . . . . . . 150 VA max.
Ambient temperature: . . . . . 0 – 40 °C
Dimensions: . . . . . . . . . . . . . 290 × 412 × 220 mm
Weight: . . . . . . . . . . . . . . . . 9 kg
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual
®

Specifications

RMS power: . . . . . . . . . . . 70 W
peak power: . . . . . . . . . . . 110 W
MIC IN: . . . . . . . . . . . . . . 15 mV/ 270 mV/ 10 kΩ
LINE IN, XLR: . . . . . . . . . 200 mV/ 4.2 V/ 20 kΩ
LINE IN, phono: . . . . . . . . 360 mV/ 7 V/ 10 kΩ
rated output voltage: . . . . 200 mV
output impedance: . . . . . . 2 kΩ
Subject to technical modification.
1 = ground
2 = signal +
3 = signal -