Table of Contents
Advertisement
Operating Instructions
Fault Codes
(continued)
4.If the display reads "PU", check the following operating conditions: a. Make sure the pump drain hose is well connected.
b. Check that the hose is not blocked, kinked or frozen. c. Remove and empty the water bucket to check the bucket pickup
for blockage of dirt or alge. d. Turn off the unit and restart it under normal operating conditions. e. Unplug the unit and plug
it in again under normal operating conditions. If the "PU" code persists, contact your Authorized Frigidaire Service Center.
Note:
1.If your unit does not pump water, you need to check below first: a. Check the pump is turned on. b. The unit will not pump
untill it reaches the full bucket point.
2.Please follow the steps described in "Emptying the Bucket" to remove and empty the water bucket.
3.Please follow the steps described in "Care and Cleaning" to clean the unit regularly to prevent dirt or alge.
Removing Collected Water
1. Emptying the Bucket:
a. When the bucket is full, the unit will shut down and the BUCKET FULL indicator will illuminate.
b. Do not move the unit at this time otherwise water may spill on the floor.
c. Press sides of bucket gently to unclip the bucket from the unit.
d. Remove the bucket as shown in the photographs below and empty the bucket.
WARNING
Discard water from bucket. Water is not potable and cannot be used for drinking.
e. Replace the empty bucket back into the unit and once seated correctly, the unit will start up again.
f. You should hear a click when the bucket is in the correct position
8
2019 Electrolux Home Products, Inc.
All rights reserved.
Hide quick links:
Advertisement
Table of Contents
