Table of Contents
Advertisement
Operating Instructions
Operating Instructions
(continued)
5. The Filter reset light will illuminate after 250 hours of operation. At this time refer to the care and cleaning section
to remove and clean the filter. Once the filter has been cleaned and replaced, simply press the Filter reset button
to extinguish the light.
6. The TIMER function enables you to either Delay Start or Delay Stop the unit in the choice from 0.5 hour to 24 hours.
If the unit is running, then selecting Timer will turn the unit off in the hours that will be set (Delay Stop). If the unit is
off, then selecting Timer will turn the unit on in the hours that will be set (Delay Start).
TIMER setting: First press TIMER button, then adjust timer setting, by tapping or holding the
change the delay timer at 0.5 hour increments, up to 10 hours, then by 1 hour increments up to 24 hours. The
control will count down the time remaining (8,7.5,7, etc.) until the unit either starts or stops. For the Delay Start, the
fan speed and humidity maintained will be the same as previous setting. After TIMER setting finishes, pressing TIMER
button again at any time will stop the TIMER function. The Delay Start/Stop Feature will work until the unit either
starts or stops. Once that happens the above steps have to be repeated.
NOTE:
1. Before entering TIMER setting, make sure power is being supplied to the unit.
2. Before entering TIMER setting, make sure pressing HUMIDITY
7. Press PUMP button, the unit will enter water pump mode. Pump Mode Indicator will be on. When the water tank is
full of water, the pump will start to pump water automatically. The pump will stop automatically after the water tank have
been empty.
NOTE:
pump drain hose in the bucket is installed properly.
6
2019 Electrolux Home Products, Inc.
or
button sets one desired room humidity first.
or
button to
All rights reserved.
Hide quick links:
Advertisement
Table of Contents
