LENCO CRW-110WH User Manual page 18

Sunrise light simulation
On alarm mode F1 or F2, the sunrise will start 30 minutes prior the configured alarm time, gradually increasing to
reach the selected brightness at your configured alarm time. You need to activate the alarm before you go to sleep.
At the alarm time, sounds and/or light will last for 5 minutes. You can press any button except
alarm for 24 hours. Alarm will still work normally at the configured alarm time, the next day (if the
kept highlighted on the display)
Note: When the sunrise alarm function is active
1. Pressing or
2. Long pressing
SUNSET LIGHT SIMULATION
Under mode F1 or F2 the sunset light starts at the selected brightness/sound volume with
fades to off over the selected minutes. When is faded off the
Sunset mode
1. Press , the
2. Use or
3. Press again to confirm and continue.
Sunset sound
4. Use or
5. Press again to confirm and continue.
Sound volume
6. Use or
7. Press again to confirm and continue.
Sunset light brightness
8. Use or
9. Press again to confirm and continue.
Sunset time
10. Use or
will stop the sunrise simulation and fix at the current brightness level.
will turn off the sunrise light.
symbol appears and the display flashes.
to select sunset mode F1, F2 or F3. (F1=Sunset Light + Sound, F2= Sunset Light, F3= Sound).
to set a sunset sound (1-8 is preset sound, 9 is recording voice,10 is FM radio)
to set the volume from 01 to 15 levels (Default is level 05).
to set the brightness of sunset light from 01 to level 30 (Default is level 10).
to select 15 or 30 or 60 as the sunset fading minutes.
symbol disappears.
18
to stop the
or is
flashing and gradually