Operation; Installing Hook - Makita WT02 Instruction Manual

Installing or removing impact socket
1
► 1. Impact socket 2. Square drive
To install the impact socket, push it onto the square
drive of the tool until it locks into place.
To remove the impact socket, simply pull it off.

Installing hook

CAUTION:
When installing the hook, always
secure it with the screw firmly. If not, the hook
may come off from the tool and result in the personal
injury.
2
3
► 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool. To install
the hook, insert it into a groove in the tool housing on
either side and then secure it with a screw. To remove,
loosen the screw and then take it out.
2
1

OPERATION

CAUTION:
Always insert the battery cartridge
all the way until it locks in place. If you can see the
red indicator on the upper side of the button, it is not
locked completely. Insert it fully until the red indicator
cannot be seen. If not, it may accidentally fall out of
the tool, causing injury to you or someone around
you.
Hold the tool firmly and place the impact socket over
the bolt or nut. Turn the tool on and fasten for the proper
fastening time.
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
Proper fastening torque for standard bolt
N•m
(ft•lbs)
140
(100)
120
(90)
100
(70)
2
80
(60)
60
(40)
40
(30)
20
(10)
0
1. Fastening time (second) 2. Fastening torque
7 ENGLISH
M16 (5/8")
M16 (5/8")
M14 (9/16")
M12 (1/2")
M14 (9/16")
M10 (3/8")
M12 (1/2")
M8 (5/16")
M10 (3/8")
M8 (5/16")
1 2 3
1