Modify The Device Settings; Factory Reset; Factory Reset Setting By Software; Factory Reset Module Through At Command - Wiznet W5500S2E-Z1 Manual

5.2 Modify the device settings

After searching the module, user could directly go to "Basic Settings" and "Advance Options" to
configure the module. Please press

5.3 Factory reset

If the customer found out some uncertainties with the WIZS2E module, the user could reset the
module back to factory default setting to solve the problem. There are three kinds of method to
factory: Software (ConfigTool), AT command and hardware reset.

5.3.1 Factory reset setting by software

In the WIZS2E ConfigTool, please click the module on the search section that needs to
I.
factory reset.
II. Please press toolbar's
module back to default settings.

5.3.2 Factory reset module through AT command

For detail information about this AT command (AT+DEFAULT) for factory reset, please refer
section 6.4.2.6.
W5500S2E-Z1 user manual
Figure 5-2 WIZS2E ConfigTool advance options interface
→
W5500S2E-Z1 serial to Ethernet module
button to save your configuration.
factory reset button to reset the