Page 1
2x1 DVI KVM SL Switcher U S E R M A N U A L www.gefen.com...
Page 2
Chatsworth, CA 91311 www.gefen.com support@gefen.com Gefen Inc. reserves the right to make changes in the hard ware, packaging and any accompanying doc u men ta tion without prior written notice. 2x1 DVI SL Switcher is a trademark of Gefen Inc.
Introduction Features Panel Descriptions Connecting and Operating the SL Switcher Operation Notes RMT2-IR Installation IR Code Confl icts / IR Extender Installation Specifi cations Warranty TABLE OF CONTENTS...
Our Commitment Gefen will always offer the fi nest quality product at the best possible price. Included in that price is a lifetime of free support from a team of outstanding engineers. Now you can switch easily and reliably between any combination of two single link DVI &...
• No loss of quality • Use either PC or Mac with USB keyboard/mouse • Switches easily between any two single link DVI computers • Switch between two single link DVI, USB 2.0 and Audio Sources • IR Remote control Includes:...
PANEL DESCRIPTIONS Power Indicator Audio In 1 5VDC Input DVI In 1 Infrared Selector Indicates which input is selected Contact Closure Interface - Connects to optional wired Audio In 2 Audio Out RMT-2 remote control DVI Out DVI In 2 USB In 1 USB In 2 Output...
Page 7
6- Plug the 5VDC power supply into the SL Switcher. How to Operate the SL Switcher 1- Use the front panel push button to switch between sources. 2- Use the RMT2-IR remote control port to remotely toggle between sources. 3- Use the optional RMT-2 wired remote control to remotely toggle between sources.
This step can be eliminated using the Gefen DVI Detective, which stores the displays EDID. If you loose your picture when switch from source 1 to source 2 or vice-versa you will need a DVI Detective.
RMT2-IR INSTALLATION 1. Remove battery cover from the back of the RMT2-IR remote. 2. Verify that dip switches 1 & 2 are in the down (OFF) position. 3. Insert the battery, hold the battery so that you can see the positive side facing up. The side that is not marked must be facing down.
2. Locate the Dip Switches above the batteries 3. Switch the Dip Switches on the RMT 2-IR to any of the combinations pictured below. 4. Dip Switches 1 and 2 in the RMT 2-IR correspond with Dip Switches 1 and 2 on the outside of the 2x1 DVI SL Switcher respectively.
SPECIFICATIONS Video Amplifi er Bandwidth ... 165 MHz Input Video Signal ... 1.2 Volts p-p Input DDC Signal ... 5 Volts p-p (TTL) Single Link Range ... 1920 x 1200 DVI Input/Output Connector Type ... DVI-I 29 pin female (digital only) USB 2.0 Input Connection ...
Need help?
Do you have a question about the DVIKVM-241SL and is the answer not in the manual?
Questions and answers