Table of Contents
Advertisement
Wireless network setup
7
Select the one Network Name(SSID) in the list.
•
SSID: SSID (Service Set Identifier) is a name that identifies a wireless
network, access points, and wireless devices attempting to connect
to a specific wireless network must use the same SSID. The SSID is
case sensitive.
•
Operation Mode: Operation Mode refers to the type of wireless
connections (see "Wireless network name and Network Password"
on page 148).
-
Infrastructure: Allows wireless devices to communicate with
each other through an access point.
If your network's Operation Mode is Infrastructure, select the SSID of the
access point. Note that "portthru" is the default SSID of your machine.
8
Click Next.
If the wireless security setting window appears, enter the registered
password (Network Password) and click Next.
9
The confirmation window appears, please check your wireless setup. If
the setup is right, click Apply.
Disconnect the network cable (standard or network). Your machine should
then start communicating wirelessly with the network.
10
Insert the supplied CD into the CD-ROM drive and proceed to install the
software following the directions on the screen. When the "Connect
Printer" screen appears, select the Network (Ethernet/Wireless)
connection.
18
Turning the Wi-Fi network on/off
If your machine has a display, you can also turn on/off the Wi-Fi from the
machine's control panel using the Network menu.
1
Check whether the network cable is connected to the machine. If not,
connect the machine with a standard network cable.
2
Start a web browser such as Internet Explorer, Safari, or Firefox and enter
your machine's new IP address in the browser window.
For example,
3
Click Login on the upper right of the SyncThru™ Web Service website.
4
Type in the ID and Password, then click Login.
•
ID: admin
•
Password: sec00000
2. Using a Network-Connected Machine
167
Advertisement
Table of Contents
Troubleshooting
