Vcr Reset; Rf Channel Tuning - Sharp VC-M303HM Operation Manual

VCR RESET

1.
Press the STOP
2.
MENU
Press and hold
VCR for 10 seconds.
Please continue with your previous procedure.

RF CHANNEL TUNING

If you have a preferred RF output channel this can be set manually (21-69) by following the
procedure below.
1.
STANDBY
Press the
2.
Press and hold the
3.
Wait for a flashing channel number to appear on the VCR display.
4.
The channel number can now be changed by using the
buttons.
5.
SET
Press the
6.
Your TV will now require tuning to the new channel.
RF THROUGH ON/OFF:
If you wish to connect your VCR to the TV with only a scart lead, the RF Output on your VCR
can be turned OFF and ON by pressing the
on the remote control at point 2 of the
manual on page 5. This will help minimise interference.
If problems persist contact the SHARP Helpline on tel: 0990-274277
STOP
button on the front of the VCR.
CHANNEL
and
✔
VCR RESET IS NOW COMPLETE
button.
MENU
button on the VCR front panel for 3 seconds.
button to store.
TUNING THE TV INTO THE VCR
CH
buttons together on the front of the
CHANNEL
CLEAR
CLEAR button then the
30
CHANNEL
or
CHANNEL
SET
SET button
section of this