Panasonic PT-AE7000E Operating Instructions Manual page 49

■ [MPEG NR]
You can eliminate the noise that occurs upon projection for
videos that use MPEG compression.
Weaken
Setting range: 0 to +3
z
Attention
Use a strong setting when projecting an MPEG video.
z
COMPUTER (RGB) signal is not supported.
z
■ [FRAME CREATION]
You can activate the rendering system for fast motion
frames with fewer afterimage.
Switch settings
[OFF]
[MODE3]
[OFF] Deactivate
[MODE1] Setting for a standard image
[MODE2] Setting for a cinema image
[MODE3] Setting for a fast moving image
Note
With some of the images, it might be difficult to see a
z
difference in result.
If [FRAME CREATION] is set to active, video may be
z
delayed in some cases. In this case, select [OFF].
This cannot be set to active when [2D TO 3D]
z

( page 66) is enabled.
■ [COLOUR MANAGEMENT]
Strengthen
●Create a new profile
Note
z
z
z
Switch settings
z
z
z
[MODE1]
[MODE2]
[PICTURE] menu
For the selected [PICTURE MODE], you can adjust a
selected colour individually with [CURSOR] mode or adjust
the six colour components (Red, Green, Blue, Cyan,
Magenta, Yellow) with [RGBCMY] mode.
Adjustment results can be saved as a profile and called
later.
[COLOUR MANAGEMENT] will be unable to adjust with
the setting of [REC709] in [PICTURE MODE], when
HDMI signal is selected.
When the input signal is switched while adjusting,
adjustment details are not saved.
If there is another area, which has the exact same or
similar colour as the target on the same screen, these
colours will be adjusted as well.
You can adjust all colours except white, gray and black.
If you edit a single colour to be individual different
colours, the desired colour may not be achieved.
When a 3D signal is being input (including converting 2D
to 3D), [COLOUR MANAGEMENT] cannot be executed.
Adjusting the selected colour (when
z
[CURSOR] is selected for [ADJUSTMENT
MODE])
Select the desired colour with a cursor and adjust.
1) Press the ◄► buttons to select [CURSOR]
in [ADJUSTMENT MODE].
COLOUR MANAGEMENT
PROFILE NORMAL
ADJUSTMENT MODE CURSOR
START ADJUSTMENT
LOG
2) Press the ▲▼ buttons to select [START
ADJUSTMENT] and press the <ENTER>
button.
The cross cursor (A) is displayed, and the
z
projected image is captured.
Screen
3) Move the cursor with the ▲▼◄► buttons
to the required place to select a colour.
Align the centre of the cross cursor on the point
z
in the projected image to be adjusted.
ENGLISH - 49