Panasonic PT-AE7000E Operating Instructions Manual page 46

[PICTURE] menu
3) Adjust the tone with the ▲▼
<ENTER> button, <SUB MENU> button, or
<DEFAULT> button.
a. Changing the selected point
Using the remote control
z
The selection point moves one point to the right each
time the <SUB MENU> button is pressed. The default
setting is point 5.
Ex. 5 -> 6 ->...-> 9 -> 1 ->...
Y ADJUST
0%
POINT
Y ADJUST
0%
POINT
Using the device control
z
You can also change the [POINT] from the [GAMMA
ADJUSTMENT] menu directly.
Use ▲ ▼ to select [POINT] and ◄ ► to change the
point.
POSITION
LANGUAGE
3D SETTINGS
POSITION
LANGUAGE
3D SETTINGS
46 - ENGLISH
buttons,
50%
INPUT
5 INPUT 50% OUTPUT +10
50%
INPUT
6 INPUT 60% OUTPUT
GAMMA ADJUSTMENT
PICTURE ADJUSTMENT MODE ADVANCED
GAMMA HIGH
GAMMA MID
GAMMA LOW
POINT 5
Y ADJUST
R ADJUST
G ADJUST
GAMMA ADJUSTMENT
PICTURE ADJUSTMENT MODE ADVANCED
GAMMA HIGH
GAMMA MID
GAMMA LOW
POINT 6
Y ADJUST
R ADJUST
G ADJUST
b. Adjusting the input level
To adjust the input level from the present setting,
z
press
desired level. (It may be moved left and right.)
Setting range: from 1 to 99 % in increments of
z
1 %. (However, it cannot be set beyond the
adjacent points.)
Only available to adjust the input level in
z
the [Y ADJUST] menu and not other menus.
(Input level cannot be adjusted on the [R/G/B
ADJUST] screen.)
Ex. Press ◄ in the [Y ADJUST] menu and move the
100%
selected point leftward.
Y ADJUST
100%
Y ADJUST
0
continuously until it reaches your
0% 50%
INPUT
POINT 5 INPUT 50% OUTPUT
0% 50%
MOVE LEFT
INPUT
POINT 5 INPUT 44% OUTPUT
Setting range: 1 to 99 %
100%
0
100%
0