Westinghouse WSE7000S User Manual page 20

iNStALLiNG YoUR icE ANd wAtER fiLtER
Step 8
Push shorter tube into tap fitting past insertion mark.
Step 9
Push other end into filter INLET.
Step10
Connect remaining tube length to filter OUTLET.
Step 11
Connect other end of remaining tube length to inlet on
bottom right hand side of refrigerator back. inlet location
INSTALLATION
20
water
flow
direction
inlet location
Step 12
Turn on water and check all joints and tubes for leaks.
Step 13
Reconnect the power.
Step 14
Move the refrigerator back into place being careful not to
kink or split the tubing.
Step 15
Using a large container run the water dispenser to clear air
from lines. This may take a few minutes. Purge and dispense
a minimum of 2 litres of water. Initial water may be black
in colour. This is residual carbon dust from the filter and is
non-toxic. If the water is slow to shut off or the dispenser
is dripping, air may still be in the lines. Either purge more
water through the system to remove this air or allow some
time for the air to be removed over subsequent dispensing.