Table of Contents
Advertisement
Note: Always ensure that a memory module is installed in the Primary (red) slot.
If not, then the system will fail to start. When installing two memory modules, please
ensure that they are the same size and ideally use the same type/model for both slots.
3.
Slide the memory module to the slot at a 45-degree angle (approximately) and press
the memory module down until it clips into place. Ensure the memory module sits
properly with the clips in place.
4.
Close the NAS cover and fasten the screw. Reconnect the power and network cables
to the NAS.
5.2
TS-451S, TS-651, TS-851, TS-x53/x53S Pro, TVS-x63 series
(2/4/6/8-bay)
31
Advertisement
Table of Contents
