Table of Contents
Advertisement
OSD TIMEOUT
FRAME RATIO
4:3 MARK LINE
CENTRAL MARK
CINEMA ZONE MARK
AUDIO CHANNEL L*
AUDIO CHANNEL R*
4.1.5 Factory Reset
The monitor menu offers a Factory Reset option, which will return all the monitor settings to the
factory defaults
To reset the monitor, press the MENU button and then use the UP / Down buttons to navigate to the
FACTORY RESET option. Press ENTER again to reset the monitor. After a few seconds, the monitor
settings will return to factory defaults.
4.2 Firmware Update Procedure (Monitor)
From time to time Datavideo may release new firmware to either add new features or to fix reported
bugs in the current HS-1600T Monitor firmware. Customers can update the firmware themselves if
they wish or they can contact their local dealer or reseller for assistance should they prefer this
method.
This section describes the firmware update process and it should take approximately 15 minutes total
time to complete. Once started the update process should not be interrupted in any way as this
could result in a non-responsive unit.
To update the HS-1600T Monitor, you will need:
The latest firmware update for the HS-1600T Monitor.
This firmware file can be obtained from your local Datavideo office or dealer.
USB 2.0 pen drive with a USB A connector.
How to update the firmware
1. Unzip / extract the supplied zipped archive or rar folder.
2. Wipe the contents of the USB 2.0 pen drive so it is empty.
3. Transfer / copy the unzipped / extracted file to the USB 2.0 pen drive; make sure the file name is
renamed to MSTFLASH.bin.
4. Plug the USB 2.0 pen drive into the USB 2.0 port labelled MONITOR F/W
UPGRADE on the front of the monitor button panel.
5. Reboot HS-1600T and the update will start automatically.
6. The HS-1600T Monitor will reboot itself at the end of the process.
Note: The USB port can also be used to power the connected USB LED light.
5-120 SEC
90 / 80 / 0FF
ON / OFF
ON / OFF
ON / OFF
1/2/3/4
1/2/3/4
35
Advertisement
Table of Contents
