Chapter 3 Switcher Osd Menu; Start; Transition Type; Transition Speed - Datavideo HS-1600T-2C140TM Instruction Manual

Chapter 3
The switcher's OSD menu allows the user to perform several configurations of video effects, such as
picture-in-picture, luma key and etc. The user can also configure the audio settings in the Audio
option. In addition, in the setup option, the user is allowed to set video output resolution, reset to
factory default, and selects the interface language.

3.1 Start

Option Parameters

Transition Type

Transition Speed

WIPE Effect
WIPE Border Size
Start
WIPE Border Color
BKG Color
3.1.1 Transition Type
The HS-1600T provides two types of transition effect, which are cross dissolve (MIX) and WIPE. The
default setting is MIX.
3.1.2 Transition Speed
The Transition Speed allows the user to set the MIX or WIPE effect duration, in frames. If the
Transition Speed is set to a value of 60 then the transition will take effect over a period of 1 second if
the progressive video is chosen and 2 seconds if the interlaced video is chosen. When the AUTO
button is pressed, the transition will take the current Transition Speed defined by the user.
Switcher OSD Menu
Parameter Value or Range
MIX
WIPE
1-200 frames
1. Horizontal
2. Vertical
3. Center
OFF
Small
Middle
Large
White
Yellow
Cyan
Green
Magenta
Red
Blue
Black
White
Yellow
Cyan
Green
Magenta
Red
Blue
Black
Default Value
Mix
60 frames; the duration
in second depends on
the Program OUT
resolution.
1
Small
Red
White
22