Step 5: Tuning The Tv To Your Vcr - Sony SLV-X821MK2 Instruction & Operation Manual

Step 5
Tuning the TV to your VCR
If you have connected the VCR to your TV using the audio/video cable, skip
this step.
1
ON/STANDBY
2
RF
CH SET
3
4
RF
CH SET
PROGRAM
ON/STANDBY
RF CH SET
Press ON/STANDBY to turn on the VCR.
Press RF CH SET on the VCR.
The factory-preset RF channel appears in the display window.
The VCR signal is output through this channel to the TV.
Turn on your TV and select a program position for video playback.
Press RF CH SET.
The TV system indicator appears in the display window.
If the displayed TV system doesn't match your TV, select the correct TV system by
pressing PROGRAM +/– according to the following table. If you don't know your TV
system, please refer to the "Channel setup map and chart" on pages 8 and 9.
If your TV color system is PAL
If your TV system is Select TV system
I I
D/K K
B/G G
Tune the TV to the same channel as that shown in the display window so that a gray
screen appears on the TV screen.
Refer to your TV manual for tuning instructions.
If the gray screen does not appear clearly, see "To obtain a clear gray screen" on the
next page.
PROGRAM +/–
If your TV color system is NTSC
Select TV system
M
RF
RF
(continued)
11
-EN
Getting Started