Table of Contents
Advertisement
en Basic operation
14.8 Starting the programme
Note: If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press Start/ Reload.
1.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended,
the display shows: End.
If
is selected, the laundry is not
2.
spun and the water is drained after
rinsing.
Notes
¡ If the laundry is not removed, the
Anti-Crease programme starts after
15 minutes. The programme takes
around 30 minutes. The display
shows 0：00, ,
ternately and
Press any button to stop the Anti-
Crease programme and to remove
the laundry.
¡ If appears, the appliance cools the
laundry.
When goes out, the laundry has
cooled down.
14.9 Adding laundry
Press Start/ Reload.
1.
During the washing cycle, the ap-
pliance pauses.
During the drying cycle, the appli-
ance checks whether it is possible
to add laundry.
appears, it is not pos-
Note: If
sible to add laundry.
When
goes out, it is possible to
add laundry.
Open the appliance door.
2.
32
and End al-
appears.
Add or remove laundry.
3.
Close the appliance door.
4.
Press Start/ Reload.
5.
14.10 Cancelling the pro-
gramme
Press Start/ Reload.
1.
Open the appliance door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high, start
the Spin programme or select a
suitable programme for draining.
→ "Programmes", Page 26
Remove the laundry → Page 32.
3.
14.11 Cancelling the drying
programme
14.12 Unloading the laundry
Open the appliance door.
1.
Remove the laundry.
2.
14.13 Switching off the appli-
ance
Turn the programme selector to
1.
.
Advertisement
Table of Contents
