Updating Firmware - Speco N16NRN Quick Start Manual

3.2 Updating Firmware

1. Copy the upgrade software into the USB storage device.
2. Insert the USB storage device into the USB interface of the NVR.
3. Click Start→Settings→System→Maintenance→Upgrade to go to "Upgrade" interface. Select the USB device in
"Device Name" option and go to the path where the upgrade software exists. Select the upgrade software and
then click "Upgrade". The system may automatically restart during upgrading. Please wait for a while and do not
power off the NVR during upgrading.
After firmware is updated, the unit will restart. You can now remove the USB disk from the unit.
4. EZ Setup
After the system boots up, the EZ Setup wizard is displayed. See Figure
Tip: Check the "Enable EZ Setup next time" box to display the EZ Setup wizard every time the device is rebooted.
4.1 General Settings – Date & Time
When booting up for the first time, the device will prompt you for time settings or go to Settings→System→Date and
Time for Figure 4-1
System Time: Set the time and date format of the system
DST: Toggle Daylight Saving Time On or Off
Time format: Choose between 24-hour mode or 12-hour mode.
NTP: Specify an NTP server to synchronize the time (optional).
4
. If not, right click, and select EZ Setup.
Figure 4
5