Starting And Finishing A Communication; Changing The Sea Area; Changing The Communication Parameters; Outgoing Calls - Furuno Felcom 82 Operator's Manual

6. 9.6k DATA COMMUNICATIONS
6.5

Starting and Finishing a Communication

6.5.1

Changing the sea area

Specify a sea area using the +WOR command.
For example, to change the sea area to the Pacific Ocean:
AT+WOR=2(sea area, see below for key)<CR>
0: Auto
1: AOR-E
2: POR
3: IOR
4: AOR-W
6.5.2

Changing the communication parameters

According to the contents of communications, remote stations, and the states of
lines, change the settings as necessary.
6.5.3

Outgoing calls

Specify the number of the remote station using the D command, and then make a
call.
For example, to call 123456789 in Japan for an automatic connection via the LES
of 003:
1. If no LES is specified (when AT+WLES=000), enter: ATD003-00-81-
123456789<CR>
2. If +WLES=003 is previously specified, enter: ATD00-81-123456789<CR>.
6.5.4

Incoming calls

If a call is received, the DTE screen shows "RING."
1. If a call is received in the automatic reception mode (when register S0 is set to
non-zero), the reception sequence is automatically started.
2. In the manual reception mode (when register S0 is set to zero), enter
"ATA<CR>" after confirming the arrival of a call. The reception sequence is
started.
6-10