Table of Contents
Advertisement
Available languages
Available languages
4. Turn shutoff valve ON.
5. Check for leaks. Tighten any nuts or connections (including
connections at the valve) that leak.
Style 3
1. Unplug refrigerator or disconnect power.
2. Remove and discard the black nylon plug from the gray water
tube on the rear of the refrigerator.
3. Thread the provided nut onto the water valve as shown.
NOTE: Tighten the nut by hand. Then tighten it with a wrench
two more turns. Do not overtighten.
A. Bulb
B. Nut (provided)
4. Turn shutoff valve ON.
5. Check for leaks. Tighten any nuts or connections (including
connections at the valve) that leak.
Complete the Installation
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
2. Flush the water system. See "Prepare the Water System" or
"Water and Ice Dispensers."
NOTE: Allow 24 hours to produce the first batch of ice. Allow
3 days to completely fill ice container.
There may be an occasion when you will need to remove the
factory-installed trim kit, such as moving the refrigerator to a new
home or installing custom-made decorator panels. Please read
all instructions before removing the trim kit and decorator panels.
A
B
Remove the Door Panels
NOTE: When removing and replacing decorator panels, only the
handle is removed. All other trim pieces remain attached to the
doors.
1. Remove the refrigerator and freezer handles:
Using a Phillips screwdriver, remove the screws that hold
each handle in place.
Lift off handle. Make sure you keep screws for reattaching
handles.
2. Remove the door panels:
Open refrigerator or freezer door.
Slide out decorator panel and filler board.
Repeat process for other panels and filler boards.
Store panel and filler boards to prevent scratching.
Replace the Door Panels
1. Replace the refrigerator or freezer door panels:
Open refrigerator or freezer door.
Slide the ¹⁄₈" (3.18 mm) decorator panel into place behind
the side trim.
Push the filler board into place behind the decorator
panel.
Repeat process for other panels and filler boards.
Factory Trim Kit
(on some models)
Freezer Door
Refrigerator Door
B
A
C
B
A
A. Decorator panels
B. Filler boards
C. Handles
A
B
5
Advertisement
Table of Contents
