Operation; Basic Operation - Furuno CU-300 Operator's Manual

3. OPERATION

3.1

Basic Operation

Card drive
Insert the appropriate chart SD card (or memory card) for your area as below. For details of SD
cards, see the operator's manual for NavNet VX-2.
1. Open the card drive.
2. Insert the card (label side up) prior to turning on the power at NavNet VX2-BB.
3. Close the lid.
To remove the card, follow the instructions shown on the display of NavNet VX2 and then confirm
that the power lamp on the front panel lights. Do not read/write the data.
Power lamp
Lights (green): The power is on.
Blinks: The unit is reading/writing data.
Card box
You can store two SD cards here.
Note 1: When the connection between NavNet VX2-BB and memory card interface unit is wrong,
the NavNet VX2-BB searches for chart data in the SD card for 50 seconds, and then returns to
the normal operation. The display looks frozen, however normal operation will be restarted after
the search is completed.
To prevent loss of card data if the power suddenly goes off, it is recommended that
Note 2:
you periodically back up data to an SD card.
Card box
Card drive
(Strage for two cards)
Power lamp
(green)
9