Table of Contents
Advertisement
Setting of the IP address for the second memory card interface unit
When connecting two memory card interface units, change the DIP switch setting on the second
unit as below to change its IP address. Note that the second unit is exclusively for reading chart
card.
1. Unfasten two pan head screws (M3x8), a wing bolt and a washer for MJ connector at the rear
of the unit.
2. Unfasten four screws and the connector at the location shown below to remove the front
panel.
3. Unfasten four pan head screws at the inner front chassis to remove it.
4. Pull out the inner chassis to it.
5. Set the #4 segment of DIP switch S1 as below.
6. Re-assemble the unit.
4
3
2
1
OFF
ON
S1
PCB 19P1050
8
Advertisement
Table of Contents
