Controls - NEC MultiSync EX241UN-BK User Manual

Controls

OSD (On-Screen Display) control keys on the back of the monitor function
are as follows:
To access OSD menu, press any of the control keys.
To change signal input, press the INPUT/SELECT key.
NOTE:
Exit OSD in order to change signal input.
1 Power LED
2 Power
3 ECO/RESET
4 5-Direction-Key CENTER/EXIT Accesses OSD menu. Exits the OSD sub menu. Exits OSD Control menu.
Up
LEFT/RIGHT
Right Left
Down
DOWN/UP
5 INPUT/SELECT
* When Hot Key function is OFF, this function is disabled.
1
Indicates that the power is on or off.
Turns the monitor on and off.
Resets the OSD controls back to factory settings.
Switches among ECO MODE settings.
Activates the Auto Adjust function if ECO/RESET key is pressed for 3 seconds or
more while the OSD menu is off (analog input only).*
Navigates to the left or right through the OSD Control menu.
Move the LEFT/RIGHT key left or right to increase or decrease the adjustment.
DP OUT MULTISTREAM setting and TILE MATRIX ENABLE setting are changed if
the LEFT/RIGHT key is moved left then held for 3 seconds while OSD menu is off.*
If DP OUT MULTISTREAM setting is CLONE, the setting will be changed to AUTO.
Navigates up or down through the OSD Control menu.
You can adjust the Brightness directly by moving the DOWN/UP key up while the OSD
menu is off.*
1
You can adjust the VOLUME directly by moving the DOWN/UP key down while the
OSD menu is off.*
1
You can directly change to L/B (LOW BLUE LIGHT) mode by pressing the INPUT/
SELECT key for 3 seconds or more.
Enters the OSD menu. Enters OSD sub menus.
Changes the input source when not in the OSD menu.
English-15
1
1