Table of Contents
Advertisement
Section 1: Assembly and Set-Up
CA0548 Rotor Shaft Assembly
These instructions are for the 48" Aerator. See "CA0540
Rotor Shaft Assembly" on page 9 for 40" Aerator and
CA0556 Rotor Shaft Assembly on page 11 for 56"
Aerator.
Refer to Figure 1-5:
IMPORTANT: Make sure all gang assemblies (#2)
are installed on rotor shaft (#5) with the open side of
the spoons facing forward in rotation as shown.
1.
Turn hitch and weight tray upside down and orient as
shown. Position end panel (#1A) on the left end of the
weight tray to begin assembly of the rotor shaft.
2. Insert rotor shaft (#5) in end panel (#1A)
3. Install 1" flat washer (#6A), gang assembly (#2A),
1" flat washer (#6), spacer (#4), and second flat
washer (#6) on rotor shaft (#5).
4. Install gang assembly (#2B), 1" flat washer (#6),
center support (#3), and second flat washer (#6) on
the rotor shaft.
10
CA0540, CA0548 & CA0556 Core Aerators 325-108M
Table of Contents
5. Install gang assembly (#2C), 1" flat washer (#6),
spacer (#4), and second flat washer (#6) on the rotor
shaft.
6. Install gang assembly (#2D), 1" flat washer (#6),
center support (#3), and second flat washer (#6) on
the rotor shaft.
7.
Install gang assembly (#2E), 1" flat washer (#6),
spacer (#4), and second flat washer (#6) on the rotor
shaft.
8. Install gang assembly (#2F), and 1" flat washer (#6B)
on the rotor shaft.
9. Install end panel (#1B) on the right end of the rotor
shaft (#5).
10. For continued instructions, skip to "Weight Tray &
Rotor Assembly" on page 12.
Direction of
Rotation
CA0548 Rotor Shaft Assembly
Figure 1-5
30009
2/12/21
Advertisement
Table of Contents
