Section 1: Assembly and Set-Up
CA0540 Rotor Shaft Assembly
These instructions are for the 40" Aerator. See "CA0548
Rotor Shaft Assembly" on page 10 for 48" Aerator and
"CA0556 Rotor Shaft Assembly" on page 11 for 56"
Aerator.
Refer to Figure 1-4:
IMPORTANT: Make sure all gang assemblies (#2)
are installed on rotor shaft (#5) with the open side of
the spoons facing forward in rotation as shown.
1.
Turn hitch and weight tray upside down and orient as
shown. Position end panel (#1A) on the left end of the
weight tray to begin assembly of the rotor shaft.
2. Insert rotor shaft (#5) in end panel (#1A)
3. Install 1" flat washer (#6A), gang assembly (#2A),
1" flat washer (#6), spacer (#4), and second flat
washer (#6) on rotor shaft (#5).
2/12/21
Table of Contents
4. Install gang assembly (#2B), 1" flat washer (#6),
spacer (#4), and second flat washer (#6) on the rotor
shaft.
5. Install gang assembly (#2C), 1" flat washer (#6),
spacer (#4), and second flat washer (#6) on the rotor
shaft.
6. Install gang assembly (#2D), 1" flat washer (#6),
spacer (#4), and second flat washer (#6) on the rotor
shaft.
7.
Install gang assembly (#2E) and 1" flat washer (#6B)
on the rotor shaft.
8. Install end panel (#1B) on the right end of the rotor
shaft (#5).
9. For continued instructions, skip to "Weight Tray &
Rotor Assembly" on page 12.
Direction of
Rotation
CA0540 Rotor Shaft Assembly
Figure 1-4
CA0540, CA0548 & CA0556 Core Aerators 325-108M
30015
9