Advertisement
1.
Remove the grid trim ring (N) from the grid drain assembly (O).
2.
Apply adequate amount of plumbers putty underside of the grid trim ring
(N). Attach the grid trim ring (N) from top of the drain hole. Insert the grid
drain
assembly (O) from under the lavatory sink.
3.
Hold the grid trim ring (N) in place while threading the locknut (P) until
the locknut is snug with the underside of lavatory sink.
4.
Tighten the locknut (P).
5.
Remove the excess putty. Connect the trap (H) (check manufacturer's
instructions for installation).
Grid Drain Installation
6
REV-01 14, 13
Advertisement
