La Crosse Technology WS-2317 Operation Manual page 13

LCD. In this case, check that all cables are correctly inserted
into the correct sockets and/or check the batteries in the
outdoor thermo-hygro sensor and press and hold the PLUS
(+) key for 2 seconds, a short beep will sound to synchronize
the base station to the sensors otherwise no weather data will
be received.
Some weather readings such as wind speed and direction
may not appear immediately on the LCD if the wind-fan or
vane of the wind sensor is moved. This is due to the set
reading time intervals for the wind readings. The current wind
speed or direction will be displayed once the time reading
interval is reached. For rainfall, the interval readings may take
up to 2 minutes before the data is displayed on the LCD.
9. Mounting
Important Note
Prior to drilling mounting holes and permanently affixing any of
the units, please ensure the following points are considered:
Cable lengths of the units meet with your distance
•
requirements at the point of mounting
Signals from the sensors can be received by the base
•
station at points of mounting
Radio controlled time signal can be received at the point
•
of mounting
NOTE: The WWVB receiver is located in the base station.
Base Station
With a foldable leg at the back of the unit, the base station can
be placed onto any flat surface or wall mounted at the desired
location by the hanging holes also at the back of the unit. It is
important to check that the 433MHz (if using wireless
connection) and the WWVB radio controlled time signal can
be received before permanently mounting any of the units.
Should the base station not display the 433MHz weather data
from the sensors or the radio controlled time from the desired
location, then relocate the units. Once the signals are
received, the system can be affixed. Also if you have selected
to use cable connection, ensure that distances can reach all
desired locations before affixing any unit permanently
13