Table of Contents
Advertisement
1. Loosen the screw on side of cups
2. Remove cups
3. Install new cups
4. Tighten screw
Note: The screw in the wind cups will fit on the flat side of the metal stem on the sensor.
WIND READING 0.00: WHY DO I ONLY SEE 0.00 FOR WIND SPEED?
The 0.00 means your wind sensor is connected to your station.
•
Check that the cups spin freely. Something may be preventing movement.
•
Are your wind cups unbroken? After a storm it is good to check this.
WIND DASHES: WHY ARE THERE DASHES FOR WIND READINGS?
Dashes indicate the connection is lost between your station and the wind sensor.
•
My first thought is always to check that my
now is not, low batteries are the most common connection problem.
•
Next, check your
distance, resistance and
at the same location, this is likely not the issue. However sometimes there is new growth on
trees or bushes that cause another barrier. Radio Frequency (RF) signal does not travel well
through foliage due to the moisture content.
•
Occasionally adding a new wireless electronic device to the home will cross the signal path
for the sensor. If this occurs try moving your station a few feet or turning the station 90
degrees for a better angle to receive the sensor signal.
•
When you have good batteries, and good location, hold the SENSOR button for three
seconds to search for your sensors. If you regain connection while the sensor is mounted,
great. If you do not regain connection, bring the sensor within 10 feet of the station and
search again.
WIND INTERMITTANT: WHY DO MY WIND READINGS COME AND GO?
•
RF (radio frequency) communication may come and go occasionally. This can be normal in
some environments (e.g. moister climates).
•
If a sensor goes out, please wait 2-4 hours for it to reconnect on its own. Please be patient
– these stations can reconnect on, after many hours out.
•
RF (radio frequency) communication is not always 100% on. Certain temporary conditions
can cause it to go out for a time (e.g. 100% humidity).
If a miss happens:
•
If your wind sensor loses connection to the station for any reason, the station will show
dashes after 30 minutes.
•
The station will search for 5 minutes every hour to reconnect with wind sensor.
•
Be sure you have good batteries. Manually search for your sensor.
Try this:
batteries
are good. If it has been working and
interference. If everything was working previously
17 |
P a g e
Hide quick links:
Advertisement
Table of Contents
