Table of Contents
Advertisement
Serial terminal
The serial port on the connector panel of the projector conforms to the RS-232C interface specification, so the
projector can be controlled by a personal computer connected to this port.
■
Connection
Serial terminal
(female)
■
Pin assignments and signal names
D-Sub 9 Pin (external view)
(6)
(9)
(1)
(5)
■
Communication settings
Signal level
Sync. method
Baud rate
Parity
■
Basic format
STX
Command
Start byte
1 byte
(02h)
3 bytes
Attention
The projector cannot receive any command for 10 seconds after the lamp is switched on. Wait 10 seconds before sending
z
a command.
If sending multiple commands, check that a response has been received from the projector for one command before
z
sending the next.
When a command which does not require parameters to be sent, a colon (:) is not required.
z
Note
If an incorrect command is sent, the ER401 command will be sent from the projector to the personal computer.
z
Pin No.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
RS-232C
Asynchronous
9 600 bps
None
:
Parameter
ETX
End
(03h)
1 byte - 4 bytes
Technical information
D-sub 9 pin (male)
Signal name
—
NC
TXD
Transmitted data
RXD
Received data
—
NC
GND
Earth
—
NC
RTS
Connected internally
CTS
—
NC
Character length
Stop bit
X parameter
S parameter
Data streaming from the computer will start with STX,
and proceed to command, parameter and end with
ETX.
Parameters can be added as necessary.
Computer
Contents
8 bits
1 bit
None
None
ENGLISH - 87
Advertisement
Table of Contents
